CV1 10 P 0 5，美國伊頓比例閥

CV1 10 P 0 5，美國伊頓比例閥

A typical circuit for a single stage

feedback type valve in an open (outer)

loop application is shown in Figure 1. A

24VDC power supply is connected to

pins bdz32 (+) and bdz30 (–). An enable

switch connected between bdz32 and

pin z2a is required. The valve is

connected according to the circuit

diagram. A (+) or (–) 10V at 5mA

reference is provided for command

voltage control. When wired as shown in

the diagram, the control pots should be

2000 ohms or greater. If the pot is to be

connected across the (+) or (–) pins z2

and b2, the minimum pot size should be4000 ohms.

對于單級的典型電路

在一個開放的反饋式閥（外）

環(huán)應用在圖1 A中所示

24VDC電源連接到

銷bdz32（+）和bdz30（ - ）。使能

交換機相連bdz32之間

銷Z2A是必需的。閥門

根據(jù)該電路連接的

圖。 A（+）或（ - ）10V為5mA

參考提供了命令

電壓控制。當有線如圖

圖中，對照盆中應

2000歐姆或更大。如果鍋是要

跨越（+）連接或（ - ）引腳Z2

和b2，小鍋大小應4000歐姆。

CV1 10 P 0 5，美國伊頓比例閥